CE RoHS Certification Large Air Flow Welding And Cutting Fume Remover With φ250mm Suction Arm
- The fume extractor applies to all kinds of soot purifications caused by welding, grinding, as well as recycling of raremetals, precious materials, etc
- For the potential of fire and molten slag particles, three protective measures are used inside purifier, to make ita longer life, more secure and reliable.
- Intelligent model using PLC automatic control makes operation easy; filter rotates with the use of full-automaticcleaning in all directions, so that there is a more thorough cleaning filter surface, always to guarantee aconstant air volume absorption; Filter is made of imported microporous PTFE film.
- Power phase sequence instructions, short-circuit protection for lack of phase, with shutdown protectionmeasures when too high temperature.
- With large air volume, low noise and better capture effect. Suction hose uses the real anti-temperature, wear-resistant compounded materials, without crack and damage for sparks but longer life.
- Thick steel plate welding will produce large fume, KSZ-3.0D1 2800 m3/h air flow will meet this working condition.
- Small power ( under 2000W) and size laser cutting table, it has two pieces filters.
- Explosion-proof type dust disposal of air flow requirement under 2800 m3/h.
|Inlet Air Flow
||3x380V 50 Hz
||Polyester + PTFE
||≤74 ± 5dB(A)
||1* 3m *DN160mm
||1 * 3m *DN200/250mm